Tarp Floor And How To Stake Tight

The tarp is draped over the paracord diagonally while the leading edges fold under to form the floor.

Tarp floor and how to stake tight.

Make sure this cord is tight and holds the tarp securely to the ground. It can be made by stringing the paracord between two trees. If you have trouble getting a good pitch try playing around with the following. Tie 1 guy line around each tree roughly 4 5ft from the ground depending on the size of the tarp.

The tarp should be about 6 8 inches 15 cm off the ground all the way around. Make sure the line is tight to prevent any sagging. Throw the tarp over the line so the middle of the tarp meets the cord. The distance apart of the two front corner stakes when you first lay out the tarp.

Then stake down and tension the pole s guyline at about a 90 angle from that side of the tarp. Place a tent stake into the ground near to the point the tarps corner while it is stretched out. The a frame shelter is probably the most common shelter one can make. The 30 degree angle of the tarp s roof will create a ten foot long living area.

Do the same thing for each of the other three corners of your a frame tarp shelter. Hammer in the stakes on each corner making sure it is tightly secured. The length and angle of the trekking pole. You will also need to tie off some drip lines above the entrance of the shelter to prevent rain from running down the paracord and into the shelter.

Stake down one side of the tarp. Draping over the tarp and staking it down are the final steps required to make this standard shelter. Here s how to set up your tarp shelter as a wind shed. Tie a length of cord between the tent stake and the corner of the tarp.